Reprint Services

Welcome to the Reprint Screen Printer Discussion Forum

Reply Listing

Current topic: SMTech and Quad Screen Printers

Current Question:
	SMTech 90
When we have cut the power, all the programs is gone. (A new packup battery is on the way...)After we fixed the right language, and have redone the parameters/calibration.(strange symbols have take place in some places also). We start up for a print. But her´s the big "question mark". Even if we have put it on 1st "prin/print", it goes on and on, and wont stop. The only way is to push the emergency stop buttom. What can the problem be and have can we get a round this?
Posted: Thu Oct 18, 2007 11:57 am

Author:

Reit

Post Reply

One Reply

Message

Posted

Re: SMTech 90

Hi

The 1st thing to do is to check that the firmware is seated correctly in its socket on the Display PCB and if necessary on the Powerboard PCB.

Once this has been checked you can turn the machine back on and then re-set the Systems Parameters. This will clear out any corrupted data which maybe causing your problem.
Please be aware that this will also clear out you product files so these would have to be put back in again.

If you email Ian lennox-Gordon at Reprint. They have a written procedure to follow re the Re-set Parameters if needed.

ilg@reprintservices.co.uk

I hope that this is of help

Regards
Ian

Post Reply

Thu Oct 18, 2007 12:04 pm

The Toff

	Post a reply to this question

	Back to list of questions

	Back to list of topics

	Register

Reprint Products

Refurbished Products

Home

Logon

Forum

Stencil Printers

Spares/Bom's/GA's

Other Services

About Reprint

Contact Reprint